DigiTech RP200A Guide de l'utilisateur télécharger pdf (Page 14)

Applying Power

Before applying power to anything,set your amp(s) to a clean tone and set the tone controls to

a flat EQ response (on most amps,this would be 0 or 5 on the tone controls).Then follow the

steps listed below.

1.Turn the amp volume all the way down.

2.Connect the plug of the PS0913B power supply to the power jack on the rear panel of the

RP200 Artist.

3.Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP200 Artist’s

Master Level down to “0”.

4.Turn the power of your amplifier(s) to the on position and adjust the volume(s)to a normal

playing level.

5.Gradually increase the RP200 Artist’s Master Level to achieve the desired volume.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Pas de commentaire

DigiTech RP200A Guide de l'utilisateur Page 14